Oven clicks but will not light
We test the igniter with a multimeter and replace it if it is out of spec. Most igniter replacements take under an hour, and we carry the part on the van for brands like Wolf, Viking, Thermador, Bosch and GE.
When your gas oven won't light or your dryer stops heating, Gas Appliance Repair in Cupertino from Same Day Appliance Repair Cupertino gets you back to normal fast. We service every major brand, diagnose the fault on the first visit, and carry the igniters, thermostats and control boards needed to finish the job. One call covers diagnosis and repair.

Gas Appliance Repair in Cupertino means diagnosing and fixing the burners, igniters, thermostats, control boards and safety valves inside the gas appliances your kitchen and laundry room depend on. A gas range that clicks without lighting, an oven that runs 50 degrees cold, or a dryer that tumbles but never heats all point to specific components we test with a multimeter and clamp meter before we replace anything. We work on residential and light commercial equipment, and we verify every repair with a leak detector and a full heat cycle before we pack up.
Cupertino homes run the gamut from 1960s rancho-style houses near Rancho Rinconada to newer builds around Seven Springs and Vallco Park, and each era brings its own gas appliance quirks. Older copper and steel gas lines develop pinhole leaks; newer high-efficiency ovens throw error codes when a control board fails. If you have been searching for gas appliance repair near me Cupertino CA because your cooktop won't stay lit, we stock the igniters and thermocouples that fix the most common failures on the first visit.
Every Gas Appliance Repair in Cupertino visit includes a full diagnostic, a written quote, the repair itself, and a safety check of the gas connection. Here is what you get when you book with us, and what we can add on if you need it.
We test the appliance with a multimeter, clamp meter and leak detector to find the exact fault. You get a written quote covering parts and labor before we start. The diagnostic fee is waived when you approve the repair.
Every gas appliance repair includes a leak detector check of the gas line connection and a test of the safety valve. If we find a leak, we fix it before we leave. This is included at no extra charge on every visit.
The quoted price covers the replacement part and the labor to install it. We carry common igniters, thermocouples, gas valves, thermostats and control boards on our vans, so most repairs are finished the same day.
After the repair, we run the appliance through a full cycle. For an oven, that means heating to temperature. For a dryer, that means confirming it heats and tumbles. We do not leave until the appliance works the way it should.
Every repair carries a 90-day labor warranty and a 1-year warranty on most parts. We email your invoice and a short maintenance sheet so you know how to keep the appliance running between visits.
Call (669) 308-4259 or book online. Tell us what the appliance is doing, the brand, and your Cupertino address. We will give you a two-hour arrival window and text you when the technician is on the way. Most calls are scheduled the same day or the next morning.
The technician arrives in a marked van, introduces himself, and puts on shoe covers. He inspects the appliance, tests the gas supply with a leak detector, and uses a multimeter and clamp meter to check igniters, thermostats, valves and control boards. Diagnosis takes 20 to 40 minutes.
You get a written price for the repair before any work begins. The quote covers parts and labor, and we explain what failed and why. If the repair is not worth the cost, we will tell you straight and credit the diagnostic fee toward a replacement consultation.
Once you approve, we complete the repair on the spot whenever possible. We replace the failed component, reconnect the gas line, and run the appliance through a full cycle. We check for leaks with a leak detector and confirm the oven reaches temperature or the dryer heats before we call it done.
We clean up the work area, haul away old parts if you want, and email your invoice with a 90-day warranty on the repair and a 1-year warranty on most parts. You also get a maintenance tip sheet so you can keep the appliance running between visits.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Tests igniters, thermocouples, thermostats and control boards for correct voltage and resistance. It tells us whether a part has failed or is still good, so we do not replace parts unnecessarily.
Sniffs every gas connection for leaks before and after a repair. We use it on every gas appliance call and show you the reading so you know the line is tight.
Measures current draw on motors, igniters and control boards without disconnecting wires. It helps us spot a failing component before it fails completely.
Reveals hot spots on control boards and loose gas connections that are not visible to the eye. We use it on intermittent failures that do not show up during a standard test.
Checks gas pressure at the appliance inlet. Correct pressure is essential for safe, efficient combustion, and we verify it on every gas appliance we service.
Used to disconnect and reconnect gas lines and access internal components. Our vans carry a full set of pipe wrenches, screwdrivers, nut drivers, pliers and wire strippers.
A Monta Vista homeowner's Wolf oven clicked for 30 seconds without lighting. The family had been using the stovetop for two weeks and was ready to buy a new oven. The igniter tested out of spec on the multimeter.
We replaced the igniter with an OEM part, tested the oven to 350 degrees, and confirmed it lit within 4 seconds. The repair took 50 minutes and cost less than a quarter of a new oven.
A Rancho Rinconada family's gas dryer tumbled but never heated. Clothes took three cycles to dry. The thermocouple tested open on the multimeter, and the gas valve was partially blocked with lint.
We replaced the thermocouple, cleaned the gas valve, and ran a full cycle. The dryer reached 135 degrees in 12 minutes, and one cycle now dries a full load. The repair took 75 minutes.
A Cupertino Village condo owner smelled gas near the cooktop. The connection at the gas valve was loose and had been leaking slowly. The leak detector picked it up immediately.
We shut off the gas, tightened and resealed the connection, and tested every burner with the leak detector. The reading was zero, and all four burners lit evenly. The repair took 40 minutes.
Most gas appliance failures fall into a handful of categories. Here are the problems we see most often in Cupertino and how we solve them.
Ask a pro →We test the igniter with a multimeter and replace it if it is out of spec. Most igniter replacements take under an hour, and we carry the part on the van for brands like Wolf, Viking, Thermador, Bosch and GE.
We shut off the gas, inspect every connection with a leak detector, and repair or reseal the faulty joint. We test the line again before turning the gas back on and show you the reading so you know it is safe.
We test each component in the heating circuit, replace the failed part, and run a full cycle to confirm the dryer heats. Most gas dryer repairs are completed in a single visit.
We clean the burner heads, check the gas valve, and adjust the air mixture so flames burn blue and even. We also test the gas connection with a leak detector before we finish.
$180 - $450 for most repairs; $450 - $850 for control board or gas valve replacements
Typical 2026 pricing for Gas Appliance Repair in Cupertino runs $180 to $450 for most repairs, including the diagnostic visit and common parts. Simple igniter or thermocouple replacements sit at the low end. Control board, gas valve or sealed system work pushes toward the top. We waive the diagnostic fee when you approve the repair, and you get the full price in writing before we start. If the repair is not worth the cost, we will tell you and credit the diagnostic toward a replacement consultation.
You get a licensed technician, a written quote before work starts, a 90-day labor warranty, and a 1-year warranty on most parts. If the same problem returns, we come back at no charge. That is what a fair price should buy.
Common parts like igniters and thermocouples are inexpensive and on the van. Control boards, gas valves and specialty parts for brands like Wolf, Viking or Thermador cost more and may need to be ordered.
A standard gas range is simpler to repair than a built-in wall oven or a high-end commercial-style range. Brand matters too: premium brands use proprietary parts that cost more than standard ones.
A range that pulls out easily takes less time than a built-in wall oven that requires cabinet removal. Stacked washer-dryer combos and tight condo kitchens also add labor time.
If the repair involves disconnecting and reconnecting the gas line, or fixing a leak, that adds time and requires a leak test. We include the leak test in the quoted price.
“Our Wolf oven stopped heating two days before Thanksgiving. I called at 9 a.m. and a technician was here by 1 p.m. He diagnosed a failed igniter, had the part on his van, and we were baking by 3. The price was exactly what he quoted. I have already recommended them to two neighbors.”
Karen L.Homeowner, Cupertino Village
✓ Verified“Our gas dryer would tumble but never heat. Same Day Appliance Repair Cupertino sent a technician who tested the igniter and gas valve, found a bad thermocouple, and fixed it in under an hour. He also checked the gas line with a leak detector and showed me the reading. Fair price, no upsell.”
Raj P.Homeowner, Monta Vista
✓ Verified“I had a gas smell near my cooktop and was nervous about it. The technician arrived within two hours, found a loose connection, tightened it, and tested every burner with a leak detector. He explained what happened and did not charge extra for the safety check. I felt safe leaving the house that evening.”
Michelle T.Homeowner, Rancho Rinconada
✓ VerifiedMost gas appliance repairs in Cupertino run $180 to $450, including the diagnostic visit and the most common parts. A simple igniter or thermocouple replacement sits at the low end; a control board or gas valve replacement pushes toward the top. We waive the diagnostic fee when you approve the repair, and you get the full price before we start.
The three most common causes we find in Cupertino are a failed igniter, a dirty or faulty thermocouple, and a tripped safety valve. If your oven clicks without lighting, the igniter is usually the culprit. If the burner lights and then goes out, the thermocouple is not sensing flame. We test each component with a multimeter and leak detector to confirm the exact fault before replacing anything.
Yes. Same Day Appliance Repair Cupertino services gas ovens, ranges, cooktops, dryers and commercial kitchen equipment throughout Cupertino and Santa Clara County. We cover ZIP codes 95014, 95015, 95108 and 95170, and we handle both residential gas appliance repair Cupertino calls and light commercial work. Call (669) 308-4259 to schedule.
Most repairs take one to three hours on site once we arrive. Diagnosis runs 20 to 40 minutes, and the repair itself depends on the part. Igniters, thermocouples and gas valves are usually swapped within an hour. Control board replacements can take two to three hours because we test every function afterward. Same day gas appliance repair Cupertino appointments are often finished before dinner.
If your gas oven, range, cooktop or dryer is not working, call Same Day Appliance Repair Cupertino at (669) 308-4259. We offer same-day appointments, upfront pricing, and a 90-day warranty on every repair. Licensed, insured, and ready to help.
Book Now (669) 308-4259 →Call us at (669) 308-4259 or email info@samedayappliancerepaircupertino.com to book your appliance repair. We answer calls seven days a week and offer same-day appointments across Cupertino. Most calls are scheduled within two hours.