Ice maker not making ice at all
We test the valve and filter, thaw or replace the fill tube, and confirm water flow to the mold. Most no-ice calls are fixed in one visit with a valve or filter replacement and a line flush.
When your ice maker quits, ice maker repair Cupertino CA from Same Day Appliance Repair Cupertino gets it working again fast. We service every major brand, from Sub-Zero and Viking to Samsung and LG, in homes and businesses across Santa Clara County. Our licensed technicians diagnose the real fault, quote upfront, and carry the parts to finish most jobs in one visit. Call (669) 308-4259.

Ice maker repair Cupertino CA covers everything that stops your appliance from making ice: a failed water inlet valve, a clogged filter, a frozen fill tube, a bad thermostat, or a control board that no longer signals the cycle. We test each component with a multimeter and clamp meter, check refrigerant pressure on the sealed system with a manifold gauge set, and confirm the compressor and condenser coil are doing their job. Then we fix the actual fault, not just the symptom.
In Cupertino, ice makers fail for local reasons as much as mechanical ones. Hard water in the Santa Clara Valley scales up valves and filters, and our warm, dry summers push refrigerators to run longer, which wears out fans and control boards faster. If you have been searching for ice maker repair near me Cupertino CA and getting thin results, we are the local team that shows up with the right parts. We also handle refrigerator ice maker repair Cupertino for built-in units that other shops turn away.
Every ice maker repair visit covers a full diagnostic and the repair itself, with parts and labor warrantied. Here is what is included in a standard service call, and what we treat as an add-on so there are no surprises on the invoice.
We test the water inlet valve, thermostat, control board, and fill tube, and we check refrigerant pressure on sealed-system units. You get a clear explanation of the fault and a flat repair price before we start any work.
The quoted price covers the replacement part and the labor to install it. Common valves, thermostats, filters, and boards are on the van, so most repairs finish the same day without a return trip.
We flush the water line and check supply pressure to clear scale and sediment. This step prevents the new component from failing the same way and is included in every ice maker repair we perform.
After the repair, we run two full harvest cycles and inspect every connection for leaks. You see ice production confirmed before we leave, not a promise that it should work.
Parts and labor are covered by a written warranty. If the same fault returns inside the window, we come back and fix it at no charge. You get the warranty details in writing at the end of the visit.
Call (669) 308-4259 or book online. Tell us the brand, the model if you have it, and what the ice maker is doing. We confirm a same-day or next-day window, text you the technician's name, and note any gate or parking details for your Cupertino neighborhood.
Your technician arrives in a marked van, lays down floor protection, and pulls the refrigerator's error codes. We test the water inlet valve, thermostat, and control board with a multimeter, check for a frozen fill tube, and inspect the evaporator coil. Diagnosis takes 20 to 40 minutes.
We explain the fault in plain language and hand you a flat price covering parts and labor. You decide before we touch a screw. If the unit is beyond economical repair, we say so and credit the diagnostic toward a replacement consult instead of pushing a repair you do not need.
With your approval, we replace the failed component, flush the water line, and recharge or top off refrigerant where the sealed system is involved. Most ice maker repairs take 60 to 120 minutes. We test the full cycle and confirm ice production before we pack up.
We run two complete harvest cycles, check for leaks at every connection, and verify the bin fills at the normal rate. You get a written warranty, care tips for your model, and a clean workspace. If anything looks off in the next few days, one call brings us back.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Used to test voltage and current at the water inlet valve, thermostat, and control board so we replace only what has actually failed.
For sealed-system work, we measure refrigerant pressure and pull a proper vacuum before recharging with R-134a or R-600a.
We recover refrigerant safely and legally under EPA Section 608 rules before opening any sealed system on your ice maker or refrigerator.
These find hidden water-line leaks and cold spots behind panels without tearing your kitchen apart.
Standard hand tools for water-line fittings, valve swaps, and panel removal on built-in and freestanding units.
For clean electrical repairs on control boards, thermostats, and wiring harnesses, done to code and UL Listed standards.
A Monta Vista homeowner had a Sub-Zero built-in ice maker that stopped producing ice for two weeks. Two other shops quoted a full replacement. The bin was empty and the family was buying bagged ice.
We diagnosed a failed water inlet valve and a scaled fill tube. After replacing the valve, flushing the line, and clearing the tube, the ice maker produced a full bin within four hours. Total cost was $340, far below the replacement quote.
A cafe near Downtown Cupertino lost its commercial ice machine on a busy Saturday morning. Drink sales were down and the owner was ready to rent a replacement unit for the weekend at significant cost.
We prioritized the call, arrived within three hours, and found a failed compressor relay. We replaced the relay, tested the sealed system, and had the machine producing ice by mid-afternoon. The repair cost $420 versus hundreds in rental fees.
A Rancho Rinconada homeowner noticed a small puddle under the refrigerator every few hours. The hardwood floor near the fridge was starting to cup, and the ice maker was producing very little ice.
We traced the leak to a cracked water inlet valve and a partially blocked drain line. After replacing the valve, clearing the drain, and running two full cycles, the leak stopped and ice production returned to normal. Repair cost was $260.
Most ice maker calls fall into a handful of failure patterns. Here are the ones we see most in Cupertino homes and businesses, what happens if you ignore them, and how we fix them.
Ask a pro →We test the valve and filter, thaw or replace the fill tube, and confirm water flow to the mold. Most no-ice calls are fixed in one visit with a valve or filter replacement and a line flush.
We trace the leak with a leak detector, replace the failed valve or fitting, and adjust the fill level. We also check the drain pump and line for blockages so water goes where it should.
We replace the filter, flush the line, and sanitize the ice mold and bin. If the refrigerator's water system is the source, we service that too so every cube tastes clean.
We measure supply pressure, clean or replace the valve, and test the thermostat against spec. Adjusting the fill time and cycle length restores full-size cubes, usually in a single visit.
$180 - $850 depending on fault, brand, and parts
Typical 2026 pricing for ice maker repair in Cupertino runs $180 to $450, depending on the fault and the brand. Simple valve or thermostat replacements sit at the low end. Control board swaps, sealed-system work, and built-in Sub-Zero or Viking units push toward the higher end. We quote a flat price after diagnosis and you approve it before we start. As a Cupertino ice maker repair company, we keep pricing honest and skip the upsell.
A repair at these prices costs far less than replacing a built-in refrigerator or a commercial ice machine. Our written warranty on parts and labor means you are covered if the same fault returns, which protects the money you spend.
A clogged filter or failed valve is a quick, low-cost fix. A control board, compressor, or sealed-system issue takes more labor and parts, which raises the price. We tell you which category your repair falls into after diagnosis.
Built-in Sub-Zero, Viking, Thermador, and Bosch ice makers use proprietary parts that cost more than standard Whirlpool or GE components. We source the right part and quote the exact price before ordering.
Common valves, thermostats, and filters are on the van, so no extra cost. Specialty parts may need ordering, and we tell you the lead time and price upfront so there are no surprises.
A freestanding refrigerator is straightforward. A built-in unit may need careful removal and reinstall, which adds labor time. We note this during diagnosis so the quote reflects the real work.
“Our Sub-Zero ice maker stopped making ice right before a family party. Same Day Appliance Repair Cupertino came out the same afternoon, found a scaled water inlet valve, and had it fixed in about 90 minutes. The technician showed me the old part and explained why our hard water caused it. Ice was flowing by evening.”
Priya M.Homeowner, Monta Vista
✓ Verified“Our commercial ice machine went down on a Saturday and we were losing drink sales. They prioritized the call, diagnosed a failing compressor relay, and had us back up the same day. Fair price, no drama, and they set us up on a maintenance plan to prevent scale buildup. Highly recommend for commercial work.”
David L.Cafe Owner, Downtown Cupertino
✓ Verified“I had two other companies tell me my built-in Thermador ice maker needed a full replacement. These guys found a bad control board, ordered the part, and installed it two days later for a fraction of the replacement quote. Clean work, upfront pricing, and the warranty gave me confidence. Will use them again.”
Karen T.Homeowner, Rancho Rinconada
✓ VerifiedMost ice maker repairs in Cupertino run $180 to $450 in 2026, including the diagnostic, parts, and labor. A simple water inlet valve or thermostat swap sits at the low end. Control board replacements, sealed-system work, or built-in Sub-Zero and Viking units push toward the higher end. You approve a flat price before we start, so the number does not move.
The four most common causes we find in Cupertino are a clogged water filter, a failed water inlet valve, a frozen fill tube, and a bad thermostat or control board. Hard water in Santa Clara County scales up valves faster than in softer-water areas. If your ice maker not working repair Cupertino California call starts with a 20-minute diagnostic, we can usually name the fault on the spot.
Yes. We repair refrigerator ice makers in Cupertino California on every major brand, including built-in and counter-depth models from Sub-Zero, Wolf, Thermador, Bosch, Samsung, and LG. We also service freestanding units from Whirlpool, GE, Maytag, KitchenAid, and Frigidaire. If the ice maker shares a sealed system with the fridge, our EPA-certified techs handle that too.
Most ice maker repairs take 60 to 120 minutes once the technician is on site. Diagnosis adds 20 to 40 minutes. Same-day ice maker repair Cupertino appointments are common when you call before 2 p.m. If we need a specialty part for a built-in unit, we tell you the lead time upfront, usually one to three business days.
Call (669) 308-4259 and we will book a same-day window for your ice maker repair. Our technicians are licensed, insured, and EPA-certified, and every repair carries a written warranty on parts and labor. One call, one visit, ice back in the bin.
Book Same-Day Repair (669) 308-4259 →Call us at (669) 308-4259 or email info@samedayappliancerepaircupertino.com to book your appliance repair. We answer calls seven days a week and offer same-day appointments across Cupertino. Most calls are scheduled within two hours.